Installation Sheet

ManualsBrandsSignature Hardware ManualsPlumbingGoodwin 66" Cast Iron Soaking Clawfoot Tub with Integrated Drain, Overflow and Rolled Rim

GOODWIN

CAST IRON CLAWFOOT TUB

SKU: 931043, 931050, 931049, 931051, 931042, 916652

REVISED 04/03/2020

CODES: 306483, 512831, 306480, 306481

512830, 306484, 306482, 517325, 517324

517321, 517322, 503091, 515156, 503092

503241, 503093, 503240, 503094, 503239

503095, 503238, 503096, 503237, 503097

503236, 503104, 508557, 508558, 508559

508560, 508561, 508562, 508521, 508522

508523, 508524, 508525, 508526, 508527

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are



plumbing. Signature Hardware accepts no liability for



injury during installation.

Observe all local plumbing and building codes.

Unpack and inspect the tub for damage. If any damage

is found, contact our Customer Relations team at

1-866-855-2284.

*not included

Ensure that you have gathered all of the required

materials that are needed for the installation.





Keep the plumbing connections around the tub

easily accessible for any future maintenance that

may be necessary.

PLANNING





be found and downloaded from the product page on

our website.





recommend performing any rough-in procedures with

the tub on site. For on-site rough-in information, go to

the appropriate drain installation section.

Pencil*

Tape Measure*

Straight Edge*

Hacksaw*

Thread Sealant*

Plumber’s

Tape*

Adjustable

Wrench*

Neutral Cure

Silicone Sealant*

Damp

Cloth*

Level* Plumb Line*

For Warranty information, please visit: signaturehardware.com/services/warranty

Summary of content (6 pages)

PAGE 1
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 BEFORE YOU BEGIN TOOLS AND MATERIALS: We recommend consulting a professional if you are unfamiliar with installing bathroom �xtures and plumbing. Signature Hardware accepts no liability for any damage to the �oor, walls, plumbing, or personal injury during installation. Pencil* Tape Measure* Straight Edge* Observe all local plumbing and building codes. Unpack and inspect the tub for damage.
PAGE 2
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 INSTALLATION 3. Match each tub foot with its corresponding pod, as shown below. If the letters on your tub and feet do not match, lay the feet out on the �oor and check to see if all feet are the same size. If one pair of feet are slightly shorter than the second pair, then the shorter pair are meant to mount on the side of the tub containing the drain hole. STEP 1: ATTACHING THE FEET 1.
PAGE 3
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 STEP 2: TUB INSTALLATION 5. After all feet are attached, �ip the tub over and allow it to rest on the �oor. 1. Set the tub in the desired installation location and drop a plumb line from the center of the over�ow hole to the �oor. This will determine your drain location. Mark the drain hole location on the �oor. Important: Do not lift the tub by the feet. Be sure to lift the tub by the rim and body only. 6.
PAGE 4
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 6. The over�ow tee (A) will be attached at the points where the drain pipes intersect (B). 3. Carefully set the tub back into position and adjust the feet adjusters as necessary. Once level, apply a generous bead of silicone on the bottom of the feet. This will prevent the tub from shifting after installation. A B 7.
PAGE 5
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 11. Install the over�ow assembly with the beveled washer, over�ow plate, mounting screw (provided) and any other washers or rubber sealing gaskets included. 8. Remove the drain and over�ow assembly from the tub, and trim the pipes at the marked locations with a hacksaw. Make sure that the blade is suitable for cutting metal. 9. Apply thread sealant or plumber’s tape to the threaded ends of all pipes prior to assembly.
PAGE 6
GOODWIN CAST IRON CLAWFOOT TUB SKU: 931043, 931050, 931049, 931051, 931042, 916652 CLEANING AND MAINTENANCE 13. Attach the drain tube and �ange to the waste and over�ow tee with the sealing washer and slip nut. The beveled end of the sealing washer should face the tee. Cast iron tubs have a porcelain enamel surface that is fused to the cast iron under high temperatures and is one of the best heat-resistant coatings available.