Installation Sheet

4Cast Iron Tub Installation and Care Guide

5. Apply thread sealant or plumber’s tape to the threads

at each end of all pipes prior to installation. If two pipes

arrive attached, be sure to take them apart and apply

sealant before installing.

6. Connect the tub shoe assembly (A) and rubber washer

to the tub drain (B).

7. Install the overow assembly (C) with the beveled

washer, overow plate, mounting screw (provided) and

any other washers or rubber sealing gaskets included.

8. Attach the waste and overow tee (D) to the overow

assembly (C) and shoe assembly (A) with sealing

washers and slip nuts.

9. Attach the drain tube and ange (E) to the waste and

overow tee (D) with the sealing washer and slip nut.

10. When your tub is in place and all connections have

been made, ll the tub with water to check for any

leaks from the connections and verify that the drain is

working properly.

Press and Seal Swivel Drain

11. Finish your installation by running a bead of silicone

adhesive around the base of the tub. Wipe away any

excess sealant with a damp cloth.

TRIMMING DRAIN PIPES

1. To trim the drain shoe and overow pipes appropriately,

connect the overow and drain assemblies and pipes to

the tub.

2. The overow tee (A) will be attached at the points where

the drain pipes intersect (B).

3. Measure and mark each pipe should so that the end of

the pipe reaches a little over halfway into the overow

tee (A).

4. Trim the pipes at the marked locations with a hacksaw.

Make sure that the blade is suitable for cutting metal