Installation Sheet

2Cast Iron Tub Installation and Care Guide
TUB INSTALLATION
Before you begin, read the following installation and care instructions. Observe all local plumbing, building, and electrical
codes. Install your tub on an adequately supported and level nished oor.
Unpack and inspect your tub for damages. If any damage is found, contact Customer Service at 1-866-855-2284 and
return the tub to the packing crate. If you need assistance while installing your new tub, call Customer Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures and plumbing. Keep the
plumbing connections around the tub easily accessible for any future maintenance that may be necessary. Measure
doorways and other entry points to ensure the tub will t into the desired installation area. Signature Hardware accepts
no liability for any damage to the oor, walls, plumbing, or for personal injury during installation.
TOOLS AND MATERIALS:
ROUGH-IN
The type of drain and connection method used will vary depending on your plumbing access. Determine the type of
connection (drain tailpipe, hub adapter, or waste and overow) taking into account the height and material of the nished
oor.
Because the tub specication measurements are approximate and slight variations may occur, we highly recommend
performing any rough-in procedures with the tub on site. For on-site rough-in information, go to the appropriate Drain
Installation section. For determining drain rough-in without the tub present, continue to Steps 1 and 2 before proceeding
to drain installation.
Refer to the tub’s PDF Specications sheet. (This can be viewed/printed from the website.)
1. Determine the desired location and orientation of the tub and mark the location on the oor using the length and
width dimensions provided in the PDF Specications.
2. If the tub will have a drain only (no waste and overow), use a tape measure and straightedge to mark the centerline
of the drain location on the oor. Use the dimensions provided in the PDF Specications as a guideline. If the tub will
have waste and overow, use the dimensions provided in the PDF Specications as a guideline.
Proceed to the appropriate Drain Installation section
Pencil or Marker Tape Measure Straight Edge
Metal Blade Hacksaw Thread Sealant Silicone Sealant (100% Neutral Cure)
Adjustable Wrench Damp Cloth