Installation Sheet

REMOTE INSTALLATION

STEPS

1. Drill two 6mm (1/4 inch) diameter holes on the wall (about 1-3/4” deep).

2 Knock the anchors into the hole with a hammer.

3. Secure the holder with anchors.

4. Use the screws to secure the holder to the wall.

5. Remove the battery cover from the backside of the remote to install batteries.



Detailed steps in the diagram below:

*Please use proper mounting tools for special wall surfaces (such as wood, HDF, etc)

*The remote control holder should be installed away from the bidet’s spray trajectory

*The remote control holder should be installed within reach when seated on unit

*Make sure there is nothing to block the transmission between the toilet and its remote.

1/4”

> 1-3/4”

Anchor

Remove the

decoration strip/

remote control stand Screws

Replace

decoration strip

Complete

Remote control

1.855.715.1800

VELA & VELA PLUS

SMART TOILET

INODORO INTELIGENTE

WC INTELLIGENT

SKU: 473602, 473603