Installation Sheet

12
1.800.221.3379
SOLID SURFACE TUB WITH INTEGRAL DRAIN
BAÑERA DE SUPERFICIE SÓLIDA CON DRENAJE INTEGRADO
SKU: 948319 | 948320 | 948699 | 948700
SCRATCH REMOVAL
1. Use warm water to remove dirt and dust from
the surface.
2. Using wet #400 sandpaper, gently sand the
damaged area in the direction parallel to the scratch.
Keep the area being sanded as close to the scratch as
possible. Avoid excessive pressure or circular strokes
while sanding. Re-wet the sandpaper as needed.
3. Follow with #600 sandpaper, duplicating the
sanding method used in step 2 until the scratch is
completely removed.
4. Dry with a towel.
5. Apply a small amount of acrylic-based wax (auto-
motive wax) according to the manufacturer’s direc-
tions. Buff the surface to a shine, using a buffing cloth
or drill attachment. Repeat this process as many times
as necessary until damaged area is blended with the
tub’s finish.
CÓMO ELIMINAR RAYONES
1. Utilice agua tibia para eliminar la suciedad y el polvo de
la superficie.
2. Use papel de lija #400 húmedo, para lijar suavemente
el área dañada en la dirección paralela a la rayadura.
Mantenga el área que está lijando lo más cerca posible
del rayón. Evite presionar en exceso o realizar movimien-
tos circulares mientras está lijando. Si es necesario,
vuelva a humedecer el papel de lija.
3. Continúe con papel de lija #600, duplicando el
método de lijado utilizado en el paso 2 hasta remover
completamente el rayón.
4. Seque con una toalla.
5. Aplique una pequeña cantidad de cera acrílica (cera
para automóvil) de acuerdo con las instrucciones del
fabricante. Pula la superficie para que brille, utilizando un
paño pulidor o un accesorio del taladro. Repita este
proceso tantas veces como sea necesario hasta que el
área dañada se mezcle con el acabado de la bañera.