Installation Sheet

ManualsBrandsSignature Hardware ManualsCabinet HardwareImun 1-3/4 Inch Wide Bar Cabinet Knob

1Drawer Knob Installation Instructions

DRAWER KNOB

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do not

install. Contact Customer Service at

1.866.855.2284. If you need assistance or

have questions while installing your drawer

knob contact Customer Service.

We recommend consulting a professional if

you are unfamiliar with installing hardware

ﬁxtures. Signature Hardware accepts no

liability for any damage to the drawer or

cabinet, for personal injury during installation.

INSTALLATION

BEFORE INSTALLING IMPORTANT INFORMATION

Be sure to wear protective eye-wear when drilling.

Replacing drawer knobs is simplest when the new hardware is

the same size as the old hardware. If the new knobs are smaller

than the old knobs, markings on your drawers or cabinets from

the old knobs may show after new knobs are installed.

1. Determine the position of the drawer knob. Use the tape

measure to ﬁnd the center of the drawer (if you are installing

only one knob on the drawer), or divide your drawer into quarters

or a placement you prefer (if you are installing two knobs on the

drawer). Apply painter's tape to area where you plan to aﬃx the

drawer knob.

2. Mark the exact position of the knob. Measure the exact

placement for the knob and mark it on the painter's tape.

3. Drill screw holes. Using a drill bit the same size as the knob's

screws, drill a hole in the marked location until the drill bit

reaches the inside of the drawer. Remove the painter's tape.

4. Aﬃx the knob. Place the knob screw from inside of the drawer

until it reaches the front of the drawer. Twist the knob on the

screw until it is tightened. Make sure not to over tighten or you

risk stripping the wood.

Before installing, read entire drawer knob

installation instructions. Observe all local

building and safety codes. For the following

installation instructions it is assumed that

any old ﬁxtures have been removed and any

repairs to the door have been completed.

Drill

Tape Measure

Safety Glasses

Painter’s Tape

Knob

Screw

Screw holes