Installation Sheet

Wall Register Installation Instructions

WALL REGISTER INSTALLATION

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do

not install. Contact Customer Relations at

1.866.855.2284. If you need assistance or

have questions while installing your wall

We recommend consulting a professional if

you are unfamiliar with installing hardware.

Signature Hardware accepts no liability for

any damage to the wall, or for personal injury

during installation.

BEFORE INSTALLING

INSTALLATION

1. Remove the old wall register. If the existing register is

screwed to the wall, use a screwdriver to remove the screws

that hold the register in place.

2. Insert the new wall register. The louver frame will ﬁt into the

air duct opening, while the lip of the register will sit ﬂush against

the wall surface. If your register came with tension spring clips,

attach them to the register before inserting (see below). The

clips will snap into place once the register is pressed into the

duct. If your register came with mounting screws, use them to

secure the register to the wall.

Before you begin, read the installation

instructions below. Observe all local building

and safety codes.

Screwdriver

2. Using the removed screws, attach the spring clips to the

1. Remove four screws from the new wall register, as shown.

Do not discard the screws.

SPRING CLIP INSTALLATION