Installation Sheet

6
ACRYLIC TUB WITH INTEGRAL DRAIN
INSTALLATION INSTRUCTIONS
Important: We recommend using the optional quick
connect drain kit for installation without underfloor
access.
1. Set the tub in the desired location and mark the
drain hole location on the floor. If needed, move the
tub away from the desired installation location so that
the plumbing can be installed. Leave a 2 1/4” diameter
hole for the tailpiece to go through. This will ensure
the supplied decorative floor flange will cover the
opening.
2. Install plumbing beneath floor level. Install trap
adapter into plumbing beneath floor level. This step
may require a professional.
3. Install the drain assembly as shown below. Apply a
small amount of silicone to the exposed threads of
the drain basket to act as a sealant when installing the
bottom portion of the assembly.
INSTALLATION:
WITHOUT UNDERFLOOR ACCESS /
SLAB FLOOR INSTALLATION
8. Fill the tub with water to check for any leaks from
the connections. Verify that the drain is working
properly.
7. If included, install the decorative cover plate for the
overflow. Set the cover plate over the opening, then
tighten the two set screws located on the bottom of
the plate. The set screws can be independently
adjusted in order to achieve the desired look.
Rubber gasket
Rubber gasket
Drain basket locknut