Installation Sheet

2Corner Toilet Installation Instructions
5. Thread the washers and nuts onto the anchor bolts.
Tip: Before tightening washers and nuts, verify that your toilet is level. If the toilet is not level place a shim under the
base of the toilet and adjust as necessary.
6. When toilet is properly aligned, nish tightening the washers and nuts onto the anchor bolts with your adjustable
wrench. Do this gradually, alternating from one bolt to the other until both are tight. Be sure not to overtighten as this
could cause cracks and damage the base of your toilet.
7. Place bolt caps over the anchor bolts on the base of the toilet.
Tip: If the anchor bolts extend too far over the top of the washers and nuts, use a hacksaw to trim to the correct
length.
8. If you are installing a two piece toilet, slide the tank bolts through the mounting holes on the top of the base of the
toilet. If your toilet has only one piece, move on to step 9.
9. Thread washers and nuts onto the tank bolts. Verify that the tank is level and alternately tighten the washers and
nuts until the tank is resting rmly on the bowl.
10. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ush the toilet several times
to check for any leaks around the back or base.
11. Attach the toilet seat.
12. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will nish the joint
between your oor and toilet bowl and divert water away from the base of the toilet.