Installation Sheet

ACRYLIC FREESTANDING TUB
WITH INTEGRAL DRAIN & OVERFLOW
3Acrylic Freestanding Tub Installation
5. Apply 100% neutral cure silicone sealant to the
underside of the drain flange and thread it through the
tub and into the drain pipe. Apply thread sealant or
plumber’s tape to the threaded connection to ensure a
water-tight seal. Tighten by hand. Wipe away any excess
sealant using a damp cloth.
Note: The bottom section of the drain may already be
pre-installed in the tub.
7. Fill the tub with water to check for any leaks from
the connections. Verify that the drain is working
properly.
8. Finish your installation by running a bead of silicone
sealant around the base of the tub where it meets the
floor. Wipe away any excess sealant with a damp cloth.
6. Install the decorative cover plate for the overflow. Set
the cover plate over the opening, then tighten the two set
screws located on the bottom of the plate. The set screws
can be independently adjusted in order to achieve the
desired look.