Installation Sheet

2Acrylic Freestanding Tub Installation
ACRYLIC FREESTANDING TUB
WITH INTEGRAL DRAIN & OVERFLOW
INSTALLATION
1. Set the tub in the desired installation location and
mark the drain hole location on the floor.
2. Move the tub away from the installation location so that
the plumbing can be installed. The drain pipe should
extend approximately 6” above the finished floor.
4. Carefully set the tub in position and adjust the tub feet
as necessary until level. Once level, apply a generous bead
of silicone on the bottom of the feet. This will prevent the
tub from shifting after installation.
Tip: Plan for the bottom of the tub to sit approximately
1/8" above the finished floor so that the weight of the tub,
water, and bather are fully supported by the tub feet rather
than the tub walls.
3. When the floor is finished, measure and cut the drain
pipe to the appropriate length depending onthe type of
drain being used, and the distance from the floor to the
drain hole.
6 inches