Specification Sheet

ManualsBrandsSignature Hardware ManualsPlumbingQuick Connect Drop-In Drain Kit

QUICK CONNECT TUB DRAIN INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

product, the home, or for personal injury during installa-

tion.

Observe all local plumbing and building codes.

Unpack and inspect the items for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

TOOLS AND MATERIALS:

1Quick Connect Tub Drain Installation Instructions

Drill

1-3/4” Screws

(x5)

Lubricant

(provided)

Long-nose Pliers

Saw

PVC Cement

Tape Measure

PVC Primer

Summary of content (5 pages)

PAGE 1
QUICK CONNECT TUB DRAIN INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the product, the home, or for personal injury during installation. TOOLS AND MATERIALS: Long-nose Pliers 1-3/4” Screws (x5) Lubricant (provided) Saw Tape Measure PVC Primer Drill Observe all local plumbing and building codes. Unpack and inspect the items for shipping damage.
PAGE 2
QUICK CONNECT TUB DRAIN INSTALLATION INSTALLATION 1. Drill a 4” diameter hole in the sub ﬂoor where the drain will be installed. 3. Cut the provided 1 ½” PVC pipe 3” shorter than the distance between the ﬂoor and the p-trap (measurement taken in step two). 2 4 5 6 7 4. Apply PVC primer and cement to the outside of the PVC pipe and to the inside of the p-trap, per manufacturer instructions. Insert the pipe ﬁrmly into the p-trap until cement is bonded. 2 3 4 5 6 7 8 9 2.
PAGE 3
QUICK CONNECT TUB DRAIN INSTALLATION 5. Apply PVC primer and cement to the outside of the PVC pipe and to the inside of the drop-in drain insert. 7. Insert the drain plug into the drop-in drain, if not already inserted. 6. Slide the drop-in drain onto the PVC pipe, using a twisting motion to ensure proper cement bond, apply pressure until the cement is fully set. Ensure that the rim of the drop-in drain sits ﬂush on the sub ﬂoor. Act quickly before cement sets. 8.
PAGE 4
QUICK CONNECT TUB DRAIN INSTALLATION 9. Install the ﬂooring surface, such as tile, leaving an opening around the drain as shown. 11. Once ready for tub installation, apply the provided lubricant to the rubber portion of the inside of the drain. Note: If you are installing a decorative tail piece and ﬂoor ﬂange, install the tile and leave an opening that is 2 1/4” diameter wide directly above the drain plug to ensure the ﬂoor ﬂange covers the hole. Floor ﬂange 10.
PAGE 5
QUICK CONNECT TUB DRAIN INSTALLATION Optional: If installing a separately purchased tail piece and ﬂoor ﬂange, measure and cut the 12” tail piece to length by measuring from tub drain connection. Make sure the measurement extends 2” past the bottom of the drop-in drain ﬁtting. 14. With caution, slowly drop the tub into position, inserting the tail piece into the drop-in drain. 13. Apply the provided lubricant to the entire tail piece being used.