Installation Sheet

EUBANKS BIDET TOILET SEAT INSTALLATION
INSTALLATION
Mounting Bracket Installation (Fig.1):
1. Insert the rubber anchors into the toilet’s seat
mounting holes.
2. Place the mounting bracket over the mounting
holes,
3. Secure the mounting bracket to the toilet using the
provided clamps, rubber washers, and screws, as
shown. Tighten using a screwdriver.
Seat Installation (Fig. 2):
1. Place the seat onto the toilet bowl.
2. Slide the seat onto the mounting bracket, as shown.
NOTE: If the seat will not fasten to the mounting
bracket, the bracket may need to be adusted. Loosen
the screws and adjust as needed.
Hose Installation (Fig. 3):
1. Connect the three-way valve and hose to the inlet
of the toilet seat.
2. Using a second hose, connect the opposite end of
the three-way valve to the toilet’s main shutoff valve
on the wall, as shown.
NOTE: Apply plumber’s tape or thread sealant to each
threaded connection.
2Eubanks Bidet Toilet Seat Installation Instructions
Bolt
Metal washer
Clamps
Mounting bracket
Rubber anchor
Mounting bracket
Seat
Hose
Water filling hole
Three-way valve
Angle valve