Installation Sheet

5Burwell Bidet Toilet Seat Installation Instructions
BURWELL BIDET TOILET SEAT INSTALLATION
TROUBLESHOOTING
PROBLEM
SOLUTION
CAUSE
Not Flushing
Poor Flushing
Water Not Warming
Seat Not Warming
Dryer Not Warming
No Air From Dryer
Nozzle Not Retracting
Nozzle Not Extending
Controller Not
Displaying
Kink in water supply hose.
Valve is turned off.
Water supply is disconnected.
Fix any kinks in hose.
Turn on the fill valve.
Reconnect the water supply.
Partial kink in water supply hose.
Valve is partially turned off.
Filter is dirty or clogged.
Fix any kinks in hose.
Turn on the fill valve.
Remove filter and rinse clean.
Water temperature is set low.
Seat is in power save mode.
Seat temperature is set low.
Reset or raise water temperature.
Swith seat to function mode.
Reset or raise seat temperature.
Seat is in power save mode.
Dryer temperature is set low.
Seat is in power save mode.
Switch seat to function mode.
Reset or raise dryer temperature.
Switch seat to function mode.
Seat is powered off.
Obstruction is interferring.
Seat is powered off.
Power the seat on.
Remove any obstructions.
Power the seat on.
Sensor is not detecting use.
Replace the battery.
Adjust body into sensing area.
Insufficient battery power.
If none of the above methods solve the issue, power off the device and
contact our customer relations team at 1-866-855-2284 for further
assistance.
If you are having an electrical issue, or the device often trips its circuit, then
the device could be faulty. Power off immediately and contact our
customer relations team at 1-866-855-2284 for assistance.
CAUTION