Installation Sheet

4Dummy, Passage and Privacy Set Installation Instructions

Front Back

E F

PRIVACY SET INSTALLATION

1. Insert the latch bolt (A) into the edge of the door.

The curved edge should touch the frame when the

door is closed.

Note: If the latch bolt plate is not ﬂush with the door,

carefully chisel out, or mortise, a small part of the door.

2. Use the latch bolt plate as a template to mark and

drill pilot holes for the mounting hardware.

3. Insert the latch bolt (A) and decorative faceplate (B)

and secure with two wood screws (C).

4. Push the latch bolt in and thread the passage

spindle (D) through the door.

5. With the spindle centered, thread the exterior door

knob (E) onto the latch bolt assembly. Insert the

interior door knob (F), ﬁtting it over the spindle and

aligning the screws holes.

6. Hand thread the mounting hardware (H) through

the exterior door knob and tighten ﬁrmly with a

screwdriver.

7. Thread the privacy pin (I) through the interior door

knob into the pin hole in the latch bolt. Rotate the pin

clockwise to tighten.

8. Place a small amount of paint or chalk on the end of

the latch bolt (A). Close the door and turn the knob

several times to transfer the paint onto the door

frame to mark the strike plate location.

9. Position the strike plate (G) on the door frame. The

curved edge should touch the curved edge of the

latch bolt when the door is closed.

Note: If necessary, mortise the area around the hole so

that the strike plate will lie ﬂush with the door frame.

10. Secure the strike plate (G) to the door frame with

the remaining wood screws (C).