Installation Sheet

ManualsBrandsSignature Hardware ManualsPlumbingKenora 50" Acrylic Soaking Corner Tub with Pre-Drilled Overflow Hole

1Acrylic Tub Installation and Care Guide

CONTENTS

Tub Installation.............................................................................2

Rough-In.....................................................................................2

Drain Installation...........................................................................3

Drain without Overow................................................................3

Waste and Overow Drain..........................................................3

Trimming Drain Pipes..............................................................4

Cleaning and Maintenance..........................................................5

Scratch Removal..........................................................................5

ACRYLIC FREESTANDING TUB

INSTALLATION INSTRUCTIONS AND CARE GUIDE

Summary of content (5 pages)

PAGE 1
ACRYLIC FREESTANDING TUB INSTALLATION INSTRUCTIONS AND CARE GUIDE CONTENTS Tub Installation.............................................................................2 Rough-In.....................................................................................2 Drain Installation...........................................................................3 Drain without Overflow................................................................3 Waste and Overflow Drain.......................................
PAGE 2
TUB INSTALLATION Before you begin, read the following installation and care instructions. Observe all local plumbing, building, and electrical codes. Install your tub on an adequately supported and level finished floor. Unpack and inspect your tub for damages. If any damage is found, contact Customer Service at 1-866-855-2284 and return the tub to the packing crate. If you need assistance while installing your new tub, call Customer Service.
PAGE 3
DRAIN INSTALLATION DRAIN INSTALLATION (NO OVERFLOW) 1. Set the tub in the desired installation location and mark the drain hole location on the floor. If your tub is not present, mark the location determined in the Rough-In section. 2. Move the tub away from the installation location so that the plumbing can be installed. The drain pipe should extend approximately 6” above the finished floor. 3.
PAGE 4
5. Apply thread sealant or plumber’s tape to the threads at each end of all pipes prior to installation. If two pipes arrive attached, be sure to take them apart and apply sealant before installing. C Press and Seal Swivel Drain 6. Connect the tub shoe assembly (A) and rubber washer to the tub drain (B). 7. Install the overflow assembly (C) with the beveled washer, overflow plate, mounting screw (provided) and any other washers or rubber sealing gaskets included. Press and Seal Swivel Drain 8.
PAGE 5
CLEANING AND MAINTENANCE Wash your tub at least once a week with a gentle soap, such as dish-washing liquid, and warm water. Do not use any abrasive cleaning pads or materials; we recommend the use of a soft sponge or microfiber washcloth. Vinegar can be used to remove hard water buildup and mildew. Rinse with warm water and dry with a clean, soft cloth after each use. Clean the silicone bead at base of the tub regularly with a 50/50 mix of water and chlorine bleach.