Installation Sheet

4Victorian Widespread Faucet Installation Instructions
VICTORIAN WIDESPREAD FAUCET
11. Attach the main water lines to the proper inlet on
the bottom of each valve stem. Use an adjustable
wrench to tighten, but be careful not to overtighten.
Apply thread sealant or plumber’s tape to each
threaded connection. Ensure that you are connecting
the hot and cold lines appropriately.
12. To complete the installation, install the faucet
handles using a Philip’s screwdriver.
14. Remove the aerator from the spout and turn the
faucet on for approximately 60 seconds to allow any
dust or loose sediment to exit the water lines. Check
for any leaks. Test both hot and cold water to ensure
they are running properly. Once testing is complete,
reattach the aerator.
13. Once installation is complete, turn the main water
supply back on from below your sink. Check for any
leaks underneath.
ON