Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsSignature Hardware Victorian 1.2 GPM Widespread Bathroom Faucet - Drain Assembly Included
12345678
2
VICTORIAN WIDESPREAD FAUCET
5. Reattach the T-connector to the end of the
threaded shank by hand tightening. Apply plumber’s
tape or thread sealant to the threads before tightening.
Ensure that the inlets of the T-connector are pointing
left and right.
3. Set the spout into the center faucet hole. Position
the decorative escutcheon so that the hole for the
drain’s lift rod is in the back.
4. From beneath the countertop, slide the metal
washer back onto the threaded shank. Hand tighten
the lock nut, then finish tightening using an adjustable
wrench.
Important: The opening on the metal washer should
line up with the hole in the escutcheon reserved for the
lift rod, to allow the lift rod to pass through.
Victorian Widespread Faucet Installation Instructions
6. The faucet’s valve stems are labeled by colored
plastic washers - blue for ‘cold’ and red for ‘hot.’ On the
‘cold’ valve stem, loosen the lock nut to its furthest
point at the bottom of the stem.