Installation Sheet

5. Connect the main water supply lines to the faucet.
Apply plumber’s tape or thread sealant to the threads
before tightening. Use an adjustable wrench to tighten,
but be careful not to overtighten. Ensure that you are
connecting the hot and cold lines appropriately.
ELNORA BRIDGE FAUCET INSTALLATION
7. Proceed to the drain installation. Once completed,
remove the aerator from the spout and turn the faucet
on for approximately 60 seconds to remove any dust or
loose sediment from the water lines. Ensure that there
are no leaks, and that both hot and cold water are
running properly. Turn the water off and reattach the
aerator.
6. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
3Elnora Bridge Bathroom Faucet Installation Instructions
ON
hot
cold