Installation Sheet

2
INSTALLATION
1. Set the tub in the desired installation location and
drop a plumb line from the center of the overflow hole
to the floor. This will determine your drain location.
Mark the drain hole location on the floor.
2. Move the tub away from the installation location so
that the floor plumbing can be installed. Place the drain
pipe at the appropriate height for the waste and
overflow piping. To determine this, you will need to
temporarily fit your drain pipe into the tub and measure
from the floor to the center of the drain pipe.
3. Carefully set the tub back into position and adjust
the leveling feet as necessary. If your tub does not
have leveling feet, shims may be used. Once level,
apply a generous bead of silicone on the bottom of
the feet. This will prevent the tub from shifting after
installation.
4. Next you will need to trim your drain and overflow
pipes to the appropriate sizes. Steps 5-8 will walk you
through.
5. To trim the drain and overflow pipes appropriately,
you will need to temporarily fit the overflow and drain
assemblies to the tub.
CAST IRON PEDESTAL TUB
Cast Iron Pedestal Tub Installation Instructions