Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsSignature Hardware 1.2 GPM Bridge Bathroom Faucet with Pop-Up Drain Assembly
123456
58” Bridge Bathroom Faucet Installation Instructions
8” BRIDGE BATHROOM FAUCET INSTALLATION
3. From beneath the sink, reattach the flange by
threading it back onto the drain body.
5. Position the drain so that the lever is facing the back
of the fixture, in line with the faucet’s lift rod. While
holding in place, hand tighten the lock nut until secure
then finish tightening with a basin wrench. Be careful
not to overtighten, which can crack a fragile sink.
4. Connect the drain lever by threading it into the hole
on the side of the drain body. The lever must pass
through the hole in the stopper tailpiece to function
properly. Apply a bit of thread sealant or plumber’s tape
to the threads before attaching.
6. If not already installed, insert the faucet’s lift rod into
its designated hole on the back of the faucet.