Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsSignature Hardware 1.2 GPM Bridge Bathroom Faucet with Pop-Up Drain Assembly
123456
8” BRIDGE BATHROOM FAUCET INSTALLATION
INSTALLATION
3. From below, slide the metal washers onto the thread-
ed shanks. Thread the locknuts onto the shanks until
hand-tight, then finish tightening using an adjustable
wrench.
1. Ensure that the water supply below your sink is
completely shut off by turning the shutoff valves all the
way to the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
2. Attach the provided threaded shanks into the base
of the faucet, as shown below. Insert the faucet into its
prepared mounting location.
28” Bridge Bathroom Faucet Installation Instructions
4. Remove the locknut and metal washer from the trim
piece for the drain’s rod. Insert the trim piece into the
center faucet hole, then secure from below using the
metal washer and locknut.
OFF