Installation Sheet

2Acrylic Clawfoot Tub Installation Instructions
ACRYLIC CLAWFOOT TUB
INSTALLATION
STEP 1: ATTACHING THE FEET
1. Carefully lay the tub upside down on towels or other
padding so that the bottom of the tub is facing up.
Remove the washers and nuts from the threaded studs
on the bottom of the tub.
2. Place the provided metal bars over the threaded
studs.
3. Thread a washer and nut onto each stud. Do not fully
tighten the nuts; the bar needs to be able to slide back
and forth to allow adjustment until the foot is attached.
4. Fit the foot to the metal bar and tub. Secure the foot
to the end of the bar with the flat washer, locking
washer, and bolt.
5. Once the feet are in position and adjusted appropri-
ately, tighten the nuts that were used to secure the bar
to the bottom of the tub.
Important: Do not to over-tighten. Overtightening
could strip the bolt and/or crack the tub body.
PROCEED TO THE APPROPRIATE FOOT INSTALLATION
METHOD FOR YOUR TUB.
FEET WITH MOUNTING BAR