Installation Sheet

Leta Single Hole Faucet Installation Instructions
LETA SINGLE HOLE FAUCET INSTALLATION
5. Apply plumber’s tape or thread sealant to the
threading on each braided water line. Attach the water
lines to your main water supply lines. Ensure that you
are connecting the hot and cold lines accordingly. Use
an adjustable wrench to tighten, but be careful not to
overtighten.
3
6. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
7. Remove the aerator from the spout and turn the
faucet on to remove any dust or loose sediment from
the water lines. Check for leaks. Check to ensure that
both hot and cold water are running properly. Allow the
water to flow for approximately 60 seconds, then
reattach the aerator.
ON
ColdHot
60 sec