Installation Sheet

1Centerset Faucet Installation Instructions
CENTERSET FAUCET
INSTALLATION INSTRUCTIONS
Before installing, read entire Centerset Faucet Installation Instructions. Observe all local building and safety codes.
For the following installation instructions for your new Centerset Faucet it is assumed that any old xtures have been
removed and any repairs or modications to the water supply have been completed.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1-866-855-2284. If you need assistance or have questions while installing your Centerset Faucet, contact
Customer Service.
We recommend consulting a professional if you are unfamiliar with installing kitchen xtures. Signature Hardware
accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.
Turn off the water supply at the sink where the new faucet is being installed.
TOOLS AND MATERIALS:
INSTALLATION
1. Secure the plastic deck plate to the underside of the faucet base. It should t inside the faucet base so that it is hidden
when your faucet is installed.
2. Apply a bead of silicon sealant to the underside of the deck plate. Run the silicone around the footprint of the faucet.
3. Assemble the faucet and insert into the mounting holes. Align the faucet so that it is parallel to the back of the sink and
press rmly into place.
4. Thread a basin nut on each faucet tail-piece. Hand-tighten, alternating from one to the other to bring the faucet down
evenly over the gasket.
5. Check to make sure that your faucet is properly aligned. From beneath the sink, tighten the mounting hardware with
your basin wrench.
6. Wipe away any excess sealant around the base of the faucet using your damp cloth.
7. Hand tighten to attach the water feed tubes to the main water supply, being careful not to cross the two during
installation. Give a ¼ turn with pliers or wrench, but don’t over tighten. Curve tubes as necessary to ensure there are no
kinks or knots.
8. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the
water to ow through the spout for approximately 60 seconds.
Adjustable Wrench Silicone Sealant Plumber’s tape
Damp Cloth Basin Wrench