Installation Sheet

ROSEANNA WIDESPREAD FAUCET INSTALLATION

7. Install the ‘hot’ handle onto the stem’s spindle.

Once installed, loosen the bell ﬂange until none of

the spindle is exposed, as shown.

8. From beneath the sink, position the stem so that

the outlet on the side of the stem is pointing inward,

towards the T-connector. While holding in place, hand

tighten the lock nut. Finish tightening using a basin

wrench.

5. Thread one of the provided lock nuts onto each of

the valve stems. Thread to the bottom of each stem.

Slide one of the provided plastic washers, followed by

a rubber washer, onto each stem as well.

6. One of the faucet’s valve stems are labeled by

color - red for ‘hot.’ From below, insert the ‘hot’ valve

stem into the left-side faucet hole, as shown. From

above, thread one of the provided bell ﬂanges onto

the stem.

3Roseanna Widespread Faucet Installation Instructions

Lock Nut

Plastic Washer

Rubber Washer

Make sure stem is

pointing inward,

then tighten.