Installation Sheet

ROSEANNA WIDESPREAD FAUCET INSTALLATION
INSTALLATION
3. Insert the spout into the prepared center mounting
hole. From below, Slide one of the provided rubber
gaskets onto the threaded shank, followed by the
metal washer. Secure the the spout to the surface
using the lock nut. Tighten firmly with a basin wrench.
4. Reattach the T-connector to the spout in the
reverse order of its removal, as shown. Ensure that the
rubber o-ring is seated properly, and that the nut is
tightened firmly using an adjustable wrench.
1. Ensure that the water supply below your sink is
completely shut off by turning the valve all the way to
the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
2. Remove the T-connector from the spout in order.
To remove the T-connector, first remove the nut that
is holding it in place, as shown. Set the parts aside.
2Roseanna Widespread Faucet Installation Instructions
OFF
Lock Nut
T- Connector
Lock Nut
T- Connector
Lock Nut
Metal Washer
Rubber Gasket