Installation Sheet

DALLES WIDESPREAD FAUCET INSTALLATION
INSTALLATION
3. From below, slide the provided metal washer onto
the threaded shank. Then, secure the spout by
reattaching the lock nut. Hand tighten, then finish
tighting using an adjustable wrench. Reattach the
T-connector.
Important: The opening on the metal washer should
face the back of the faucet so that it will line up with
the hole for the drain’s lift rod.
4. The faucet’s hot valve stem is labeled with a red ring
along the upper edge of the handle splines. Thread
one of the provided lock nuts onto this valve stem,
with the flat side of the lock nut facing up. Thread to its
furthest point at the base of the stem, then slide one
of the plastic washers onto the stem.
1. Ensure that the water supply below your sink is
completely shut off by turning the valve all the way to
the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
2Dalles Widespread Faucet Installation Instructions
2. Remove the T-connector and lock nut from the
spout’s threaded shank. Insert the spout into its
prepared mounting hole.
OFF