Installation Sheet

DALLES WIDESPREAD FAUCET INSTALLATION
10. Connect the valve stems to the main water
supply. Apply plumber’s tape or thread sealant to the
threads before tightening. Turn the faucet on and
allow the water to flow for approximately 60 seconds.
Ensure that there are no leaks, and that both hot and
cold water are running properly.
9. Use the provided braided water lines to connect the
hot and cold valve stems to the T-connector. Use an
adjustable wrench to tighten, but be careful not to
overtighten. Apply thread sealant or plumber’s tape
to each threaded connection before attaching.
4Dalles Widespread Faucet Installation Instructions
1 min
DRAIN INSTALLATION
Nut
Stopper
Stopper Tailpiece
Lever
Drain Flange &
Flat Rubber Gasket
Clip
Link
Thumb
Screw
Lift Rod
Body