Instructions / Assembly

Installation Instructions - Checker Cedar Lattice
Top Fence Panel Kit
A Note to Start:
First, Always wear Safety Glasses when assembling. Second, you will be
assembling the panel upside down because we have found that customers have
most success doing this to keep all components tight to the Top which is of course
the most visible part. At all steps below, using an exterior rated Glue would be an
asset but it is certainly not required.
Step 1: Using 2 screws assemble one side to the top by inserting the small male
Tenon on the end of the side into the mating groove in the top and installing 2
screws through the top piece and into the end of the side. (Now you have a
square angle.)
Step 2: While supporting the side you just installed roll it up to lay the top upside
down with the side piece standing vertical like the Letter “L”. (Prop against a wall
or other support)
Step 3: Lay Lattice piece #1 then Lattice Divider and then Lattice Piece #2 in
mating groove in Top. Verify it is snug fit pressed tight to side piece.
Step 4: Lay Center Rail on top of lattice and while pressing down on Center Rail
use 2 screws through the Side piece into the end of the Center Rail. (Snug tight.)
Step 5: After verifying lattice is pressed tight to the opposing Side install 1 screw
through Groove in Center Rail down into Center Lattice Divider. (Now the open
end of the lattice should match the end of the Center Rail where side is missing)