Installation quide

THIS PRODUCT IS FOR INDOOR USE ONLY! OUTDOOR USE COULD RESULT IN SHOCK, FIRE OR SERIOUS BODILY INJURY

OR DEATH. ALL WIRING MUST BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRIC CODES. IT IS STRONGLY

RECOMMENDED THAT YOU USE A QUALIFIED ELECTRICIAN.

THIS FIXTURE MUST BE MOUNTED TO A UL LISTED OUTLET BOX CAPABLE OF SUPPORTING THE FIXTURE.

FAILURE TO FOLLOW THIS REQUIREMENT COULD RESULT IN THE FIXTURE FALLING CAUSING SERIOUS BODILY INJURY OR

DEATH.

1. Disassemble the cross bar from canopy by removing the two screw provided with the canopy. Drill the expanding nut into

ceiling and attach the cross bar to the ceiling using the two screw provided with the mounting hardware pack.

2. Wrap Supply Ground Wire of lamp assembly and Supply Ground Wire of junction box together around screw of Crossbar.

Tighten the ground screw with a flat head screwdriver.

3. Connect the white or ribbed fixture wire to the white supply wire in the outlet box using the TWIST-ON wire connectors

provided. Connect the black or smooth fixture wire to the black supply wire in the same manner. Install the fixture Supply

Ground Wire under the green group screw on the crossbar wire then connect the fixture Supply Ground Wire to the supply the

Supply Ground Wire in the outlet box using the TWIST-ON sire connector provided.

4. Tuck the wires carefully inside the outlet box. Spread the electrical splices so that the black wires are on one side of the outlet

box and the white wires are on the other side. Next raise the canopy to the ceiling and attach back to cross bar by using two

screw provided with the canopy.

FINAL ASSEMBLY

1. Install a 60 watt max. Medium base type "A" bulb (not included) into each socket.

Installation of a bulb exceeding 60 watts maximum could result in fire, serious bodily injury or death.

2. Restore power after installation is fully complete. Your fixture is ready for use.

ASSEMBLY INSTRUCTION:

READ AND SAVE THE INSTRUCTIONS.

WARNING

To avoid shock, fire or serious bodily injury or death it is very important that the electricity servicing

the fixture is turned off before and during installation.

WARNING

Black or Smooth

Fixture Wire

Canopy

Outlet Box

Ground Screw

Green Ground Wire

1-4 Screw,

Supplied with

Mounting Hardware Pack

Crossbar

White or Bibbed

Fixture Wire