Important Safety Instructions

FABRIC CARE INSTRUCTIONS

The micro suede fabric covering this specic piece of furniture is so to the touch and very durable for everyday living. It is recommended

by the fabric manufacture to only clean this fabric with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher

spots that may have developed. Always checked a spot of fabric in an area that is unseen to be sure cleaning agent being used will not

discolor or fade the fabric’s nishing. Let the air dry and vacuum for the best result.

CORD AND POWER TRANSFORMER CONNECTIONS

Once the box has be removed from around the chair, you’ll noce the back is laying on the top of seat. There are couple of items to

remove from the seat poron of the chair rst. Follow the step below:

1. Remove the zip e holing the red bag with Power Transformer and it’s cord on the le as show in Figure A.

2. Control Wand is located in pocket on the outside of the chair as show in Figure A.

3. Slide the back down on the base. The back receiver bracket slide down on the mechanism arms coming up. See Figure B.

4. Connect the Power Transformer cable to the corresponding plug coming from the back of the chair.

5. Power Buon: The Power Buon

is designed to disable the power operaon. It is in the cable that connects the motor to the

transformer. It is a press buon. When the buon is pressed to the o posion, the Green Light on the Power buon will not display.

When the buon is in the on posion, the Green Light in the Power Buon will display and the unit will operate.

6. Connect the power cord into the Power Transformer.

7. Connect the power cord into an electrical outlet near where the chair will be used.

8. Press the on the wand to li the chair and the buon on the wand to lower or recline the chair.

WARNING: Cl

ear area below chair before lowering to reduce risk of injury or death.

The power buon is intended to allow you to disable the chair funcons.

To stop the chair from funconing using the power buon, press the buon so the LED light is o.

If the chair is not funconing, check the plug in and connecon of the cords rst (The order is A-B-C-D). If all connecons are good, verify

the LED is lit on the power buon. See illustraon on boom of page Figure A.

Be sure cords are clear from the chair for operaon.

May,2019

Page 4 Of 14