Important Safety Instructions
The Power Button is designed to disable the power operation. It is in the cable that connects
the motor to the transformer. It is a press button. When the button is pressed to the off position,
the Green Light on the Power button will not dis play. When the button is in the on position, the
Green Light in the Power Button will display and the unit will operate.
This Class B digital device complies to part 15 of FCC rules. “Operaon is subject to following two condions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operaon of the device.
INSTALLATION OF BACK-UP BATTERIES
2-9 Volt back-up baeries will operate the chair from the reclined
posion to the seang poson one cycle in case of a power failure.
If a power failure occurs and the chair is cycled, the 2-9 volt
beries will need to be replaced.
1. Remove the sliding door on the side of transformer to locate the
2-9 volt beries.
2. Remove the 2-9 volt baeries and replace with new baeries.
3. Replace door on the transformer.
4. Baeries not included.
TROUBLE SHOOTING
PROBLEM
Chair will not operate
POSSIBLE FACTORS
Transformer may not be connected
SOLUTIONS
Check the transformer has been correctly connected to the socket
Conrm with the wire from chair to transformer is rmly connecte
d
May,2019
Page 3 Of 14
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved.