User Manual

INSTALLATION OF BACK-UP BATTERIES - Batteries not included.
2-9 Volt back-up batteries will operate the chair from the reclined position to the seating position. The batteries will operate one cycle in
case of a power failure. Replace the batteries once per year or if used during a power failure
Remove the sliding door on the side of transformer to locate where the 2-9 volt batteries install. Figure D.
1. Install 2-9 volt batteries.
2. Replace door on the transformer.
TROUBLE SHOOTING
PROBLEM
Chair will not operate
POSSIBLE FACTORS
Transformer may not be connected
OLUTIONS
Check the transformer has been correctly connected to the socket
Confirm with the wire from chair to transformer is firmly
connected
CONTROL WAND OPERATION
WARNING: Always check under and around the chair before lowering from a raised position to make sure no children,
household pets or objects are under the chair. Never allow children to operate or play on, under or around the chair. Failure to clear
the area under and around the chair before lowering may result in serious bodily injury, death or property damage. Always store the
controller out of reach of children and unplug the chair to prevent children from using the controller.
Figure D
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved. Page 5 Of 14
January,2016
Press and hold to recline the back.
Press and hold to raise the back.
Press and hold to raise the footrest.
Press and hold to lower the footrest.
Continue to press to raise the lift chair
to standing position
DOWN
UP
WARNING
Clear area below chair
bef
ore lowering to reduce
risk of injury or death.