User Manual

6. If your model has back wings, align the male the female brackets and slide the wing down into place, See Figure C
7. Connect the Power Transformer cable to the corresponding plug coming from the back of the chair Figure A #5
8. Connect the Power Cord into the Power Transformer Figure A #6
9. Connect the power cord into an electrical outlet near where the chair will be used Figure A #7.
WARNING: Clear area below chair before lowering to reduce risk of injury or death.
The power button is intended to allow you to disable the chair functions.
To stop the chair from functioning using the power button, press the Power Button so the LED light is off.
If the chair is not functioning, check the plug in and connection of the cords first (The order is A-B-C-D), see the Figure A. If all connections
are good, verify the LED is lit on the power button. See illustration on bottom of page Figure A.
Be sure cords are clear from the chair prior to operation.
Figure B
Figure C
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved. Page 4 Of 14
January,2016