User Manual

FABRIC CARE INSTRUCTIONS

The fabric covering this piece of furniture is very durable for everyday living. It is recommended by the fabric manufacture to only clean this

fabric with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher spots that may have developed. Always check

a small spot of fabric in an area that is unseen to be sure the cleaning agent being used will not discolor or fade the fabric’s finishing. Let the

chair air dry and vacuum for the best result.

Chair Assembly

Once the chair has removed from the box, you’ll notice the back is lying on the top of the seat. Follow the steps below:

1. Some models have back wings that attach to the back, when unpacking your chair you will find these back wings packed in the back of

the chair base, Figure A #1. Please unpack the back wings and set them aside for installation later.

2. Locate the RED plastic bag that contains the power transformer, power cord, four adjustable legs and the control wand. This can be

done by turning the base over on its arms, you will see the RED plastic bag tied to the inside of the unit, Carefully cut the ties that hold the

bag remove it. Dispose of the ties and bag properly. Figure A #2

3. With the chair still on its back, remove the 4 adjustable legs from the bag and install them onto the base of the chair and then turn the

chair upright so it is sitting on the adjustable legs Figure A #3.

4. Remove the control wand from the plastic bag and connect it to the female plug located in the left side pocket of the chair, Figure A #4.

This Class B digital device complies with part 15 of FCC rules. “Operation is subject to following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the

device.

5. To install the back, align the female brackets in the back with the male brackets in the chair base, slide the back down on the base. See

Figure B. Push down on the top of the back to lock the back into position. You will hear a click from each side of the chair to ensure the

back is locked in properly.

Figure A

Page 3 Of 14

January,2016

Power Button