Operator`s manual

167 Signametrics
#define VDCSRC_IDCSNS 74 // V Source I Sense (for future implementation)
#define EXTEND_OHMS 75 //Extended Ohms
#define SYNTH_OHMS 78 // Synthesized Resistance (for future implementation)
#define THERMO_COUPLE 81 //Thermocouple Temperature
#define AC_CAPS 82 //In-Circuit Capacitance
#define RinMeasure 91 //10Meg input resistance measure (w / open terminals)
5.11.4 Range Values
The following list contains the allowed values for range setting with DMMSetRange() function. Use the
DMMGetRange() function to retrieve the currently set range
// AC and DC Volts
#define _240mV 0 // five DCV ranges
#define _2400mV 1
#define _24V 2
#define _240V 3
#define _330V 4
// AC Current
#define _2400uAAC 0 // 2.4mA
#define _24mAAC 1 // 24mA
#define _240mAAC 2
#define _2400mAAC 3 // 2.4A
// DC Current
#define _240nA 0 // 240nA (2064 only)
#define _2400nA 1 // 2.4uA (2064 only)
#define _24uA 2 // 24uA (2064 only)
#define _240uA 3 // 240uA (2064 only)
#define _2400uA 4 // 2.4mA
#define _24mA 5 // 24mA
#define _240mA 6 // 240mA
#define _2400mA 7 // 2.4A
// 2 Wire and 4 Wire Ohms
#define _24 0 // 24 Ohms range (2064 only)
#define _240 1
#define _2400 2
#define _24k 3
#define _240k 4
#define _2400k 5 // Two Meg range
#define _24MEG 6 // 2-Wire
#define _240MEG 7 // 2-Wire (2064 only)
// Diode test
#define _D100n 0 //Test current = 100nA
#define _D1u 1 // 1uA
#define _D10u 2 // 10uA
#define _D100u 3 // 100uA
#define _D1m 4 // 1mA
#define _D10m 5 // 10mA test current (2064 only)
// Capacitance: Standard Ramp type
#define _1200p 0 // 1,200pF range
#define _12n 0 // 12nF
#define _120n 1 // 120nF
#define _1200n 2 // 1.2uF
#define _12u 3 // 12uF