Operator`s manual

139 Signametrics
FRAME -17 // Communication Frame error
CV_FIFO -18 // Com receive Fifo error
RONG_GRD_VER -21 // MCU Firmwhare does not support operation
oes not have all PCI items.
ENERAL_ERR -24 // General Error
named cal file to write cal record to
5.8 Warning Codes
wing a w , the DMM continue ith the e lt indicated by
e warn the ring() function, to retrieve the string describing the warning. This
ing ma oti ased on n may be taken to correct the source of the
arning. e w re part
dicates er iteratio S_FS and NEG_ ation that the
nal lev for nge, w al.
ERTR 1 ure va for operation
M_E 1 d func d
M_E 1 d rang
DMM_C 1 coun e
M_E 105 // Dmm alread n use
P_RA 1 t change rate in Cap mode.
R_FU 1 al func
n
RR_PARAMETER 110 // wrong parameter value
N_CALIBRATED 111 // Expired Calibration. Needs service
TOO_COLD 112 // Temperature too low
TOO_HOT 113 // Temperature too high
BAD_TC_TYPE 114 // Wrong TC type
MC_STOP 115 // Microcontroller was stopped/interruped during an operation
POS_FS 116 // Positive Over Range
NEG_FS 117 // Negative Over Range
BUSY 118 // DMM is busy, wait for ready
FUNC_INACTIVE 119 // Function can not be selected, or not available for this type DMM.
NOT_OPEN 120 // Test Terminals Are not Open during Open Cal operation,
READ_INTERVL 121 // Read Interval value incompatible with Aperture.
FAIL_OPEN_CAL 122 // Can't create on-board Cal Record
CAL_SML_APRTR 123 // Failed calibrating A/D at 2.5us Aperture
6.0 Maintenance
Warning
OVERRUN -16 // Communication Overrun error
R
PARITY -19 // Com parity error
WRONG_TYPE -20 // Wrong Cal record for DMM type
W
CANT_OPEN_PCI -22 // Can't open PCI device. Already open ?
PCI_ITEMS -23 // Card d
G
NO_HS_OG -25 // High speed Out Guard comm not operating/available
CAL_STORE -26 // Error reading Cal record from local storage
REAT_CAL_FILE -27 // Can't create
C
OPEN_CAL_FILE -28 // Can't open cal file for reading cal record
CREAT_CAL_RCRD -29 // Can't create on-board Cal Record
Follo arning will to run normally w xception of the fau
th ing code. Use DMMErrSt
str y be used to n fy the user. B it, an actio
w
in
Several of th arning codes a of a normal operation. Such are DMM_CNT_RNG, which
that the count
el is too high
requires more
the selected ra
ns, or the PO FS are indic
sig hich is norm
AP _TOO_HIGH 01 // Apert lue is too high
DM _FUNC 02 // Invali tion value use
DM _RNG 03 // Invali e value used
NT_RNG 04 // DMM ter out of rang
DM _IS_INIT y initialized: i
CA TE_ERR 06 // Can'
ER NC 07 // Illeg tion selection
ERR_APERTURE 108 // Wrong Aperture selected, see rate definitio
TRIG_SAMPL_ERR 109 // Wrong number of Trigger samples
E
U