Installation manual

3-43
SIGNAMAX LLC • www.signamax.eu
• Enable Authentication Traps
3
– Issues a notification message to specified IP trap
managers whenever an invalid community string is submitted during the SNMP access
authentication process. (Default: Enabled)
• Enable Link-up and Link-down Traps
3
– Issues a notification message whenever a
port link is established or broken. (Default: Enabled)
Web – Click SNMP, Configuration. Enter the IP address and community string for each
management station that will receive trap messages, specify the UDP port, trap version,
trap security level (for v3 clients), trap inform settings (for v2c/v3 clients), and then click
Add. Select the trap types required using the check boxes for Authentication and Link-up/
down traps, and then click Apply.
Figure 3-25 Configuring IP Trap Managers
CLI – This example adds a trap manager and enables both authentication and link-up,
link-down traps.
3. These are legacy notifications and therefore when used for SNMP Version 3 hosts, they must be
enabled in conjunction with the corresponding entries in the Notification View (page 3-54).
Console(config)#snmp-server host 192.168.1.19 private version 2c 4-87
Console(config)#snmp-server enable traps 4-89