Installation manual

3-40
SIGNAMAX LLC • www.signamax.eu
Enabling SNMP Agent Status
Enables SNMPv3 service for all management clients (i.e., versions 1, 2c, 3).
Command Attributes
SNMP Agent Status – Check the box to enable or disable the SNMP Agent.
Web – Click SNMP, Agent Status.
Figure 3-23 Enabling SNMP Agent Status
CLI – The following example enables SNMP on the switch.
Setting Community Access Strings
You may configure up to five community strings authorized for management access by
clients using SNMP v1 and v2c. All community strings used for IP Trap Managers should
be listed in this table. For security reasons, you should consider removing the default
strings.
Command Attributes
• SNMP Community Capability – The switch supports up to five community strings.
• Community String – A community string that acts like a password and permits access
to the SNMP protocol.
Default strings: “public” (read-only), “private” (read/write)
Range: 1-32 characters, case sensitive
• Access Mode – Specifies the access rights for the community string:
- Read-Only – Authorized management stations are only able to retrieve MIB objects.
- Read/Write – Authorized management stations are able to both retrieve and modify
MIB objects.
Console(config)#snmp-server 4-84
Console(config)#