Installation manual

3-35
SIGNAMAX LLC • www.signamax.eu
Setting the Time Manually
You can set the system time on the switch manually without using SNTP.
CLI – This example sets the system clock time and then displays the current time and
date.
Configuring SNTP
You can configure the switch to send time synchronization requests to time servers.
Command Attributes
• SNTP Client – Configures the switch to operate as an SNTP client. This requires at least
one NTP or SNTP time server to be specified in the SNTP Server field. (Default:
Disabled)
• SNTP Poll Interval – Sets the interval between sending requests for a time update from
a time server. (Range: 16-16384 seconds; Default: 16 seconds)
• SNTP Server – Sets the IP address for up to three time servers. The switch attempts to
update the time from the first server, if this fails it attempts an update from the next
server in the sequence.
Web – Select SNTP, Configuration. Modify any of the required SNTP parameters, and
click Apply.
Figure 3-20 SNTP Configuration
Console#calendar set 17 46 00 october 18 2008 4-75
Console#show calendar 4-75
17:46:11 October 18 2008
Console#