Installation manual

3-31
SIGNAMAX LLC • www.signamax.eu
Displaying Log Messages
The Logs page allows you to scroll through the logged system and event messages. The
switch can store up to 2048 log entries in temporary random access memory (RAM; i.e.,
memory flushed on power reset) and up to 4096 entries in permanent flash memory.
Web – Click System, Log, Logs.
Figure 3-17 Displaying Logs
CLI – This example shows the event messages stored in RAM.
Sending Simple Mail Transfer Protocol Alerts
To alert system administrators of problems, the switch can use SMTP (Simple Mail
Transfer Protocol) to send email messages when triggered by logging events of a
specified level. The messages are sent to specified SMTP servers on the network and
can be retrieved using POP or IMAP clients.
Command Attributes
• Admin Status – Enables/disables the SMTP function. (Default: Enabled)
• Email Source Address – Sets the email address used for the “From” field in alert
messages. You may use a symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
• Severity – Sets the syslog severity threshold level (see table on page 3-28) used to
trigger alert messages. All events at this level or higher will be sent to the configured
email recipients. For example, using Level 7 will report all events from level 7 to level 0.
(Default: Level 7)
• SMTP Server List – Specifies a list of up to three recipient SMTP servers. The switch
attempts to connect to the other listed servers if the first fails. Use the New SMTP Server
text field and the Add/Remove buttons to configure the list.
• SMTP Server – Specifies a new SMTP server address to add to the SMTP Server List.
Console#show log ram 4-56
[1] 00:00:27 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:00:25 2001-01-01
"System coldStart notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#