Manualshelf

Installation manual

ManualsBrandsSignaMax ManualsComputer equipmentF0-065-1200 Series
71727374757677787980
3-29
SIGNAMAX LLC • www.signamax.eu
Web – Click System, Log, System Logs. Specify System Log Status,
set the level of event
messages to be logged to RAM and flash memory, then click Apply.
Figure 3-15 System Logs
CLI – Enable system logging and then specify the level of messages to be logged to RAM
and flash memory. Use the show logging command to display the current settings.
Remote Log Configuration
The Remote Logs page allows you to configure the logging of messages that are sent to
syslog servers or other management stations. You can also limit the event messages sent
to only those messages below a specified level.
Command Attributes
• Remote Log Status – Enables/disables the logging of debug or error messages to the
remote logging process. (Default: Enabled)
• Logging Facility – Sets the facility type for remote logging of syslog messages. There
are eight facility types specified by values of 16 to 23. The facility type is used by the
syslog server to dispatch log messages to an appropriate service.
The attribute specifies the facility type tag sent in syslog messages (see RFC 3164).
This type has no effect on the kind of messages reported by the switch. However, it may
be used by the syslog server to process messages, such as sorting or storing messages
in the corresponding database. (Range: 16-23, Default: 23)
• Logging Trap – Limits log messages that are sent to the remote syslog server for all
levels up to the specified level. For example, if level 3 is specified, all messages from
level 0 to level 3 will be sent to the remote server. (Range: 0-7, Default: 7)
• Host IP List – Displays the list of remote server IP addresses that receive the syslog
messages. The maximum number of host IP addresses allowed is five.
• Host IP Address – Specifies a new server IP address to add to the Host IP List.
Console(config)#logging on 4-52
Console(config)#logging history ram 0 4-52
Console(config)#end
Console#show logging flash 4-56
Syslog logging: Enabled
History logging in FLASH: level emergencies
Console#