Installation manual

3-18
SIGNAMAX LLC • www.signamax.eu
CLI – Specify the management interface, IP address and default gateway.
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the switch to be
dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the management
station is attached, set the IP Address Mode to DHCP or BOOTP. Click Apply to save
your changes. Then click Restart DHCP to immediately request a new address. Note that
the switch will also broadcast a request for IP configuration settings on each power reset.
Figure 3-7 DHCP IP Configuration
Note: If you lose your management connection, use a console connection and enter “show ip
interface” to determine the new switch address.
Console#config
Console(config)#interface vlan 1 4-186
Console(config-if)#ip address 192.168.1.254 255.255.255.0 4-338
Console(config-if)#exit
Console(config)#ip default-gateway 0.0.0.0 4-339
Console(config)#