Installation manual

3-17
SIGNAMAX LLC • www.signamax.eu
Command Attributes
• Management VLAN – ID of the configured VLAN (1-4094). By default, all ports on the
switch are members of VLAN 1. However, the management station can be attached to
a port belonging to any VLAN, as long as that VLAN has been assigned an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot Protocol
(BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has been
received from the server. Requests will be broadcast periodically by the switch for an IP
address. (DHCP/BOOTP values can include the IP address, subnet mask, and default
gateway.)
• IP Address – Address of the VLAN that is allowed management access. Valid IP
addresses consist of four numbers, 0 to 255, separated by periods. (Default: 0.0.0.0)
• Subnet Mask – This mask identifies the host address bits used for routing to specific
subnets. (Default: 255.0.0.0)
• Gateway IP address – IP address of the gateway router between this device and
management stations that exist on other network segments. (Default: 0.0.0.0)
• MAC Address – The physical layer address for this switch.
• Restart DHCP – Requests a new IP address from the DHCP server.
Manual Configuration
Web – Click System, IP Configuration. Select the VLAN through which the management
station is attached, set the IP Address Mode to “Static,” enter the IP address, subnet
mask and gateway, then click Apply.
Figure 3-6 Manual IP Configuration