Installation manual

4-339
SIGNAMAX LLC • www.signamax.eu
• If you select the bootp or dhcp option, IP is enabled but will not function until a
BOOTP or DHCP reply has been received. Requests will be broadcast periodically
by this device in an effort to learn its IP address. (BOOTP and DHCP values can
include the IP address, default gateway, and subnet mask).
• You can start broadcasting BOOTP or DHCP requests by entering an ip dhcp
restart command, or by rebooting the switch.
Note:
Only one VLAN interface can be assigned an IP address (the default is VLAN
1). This defines the management VLAN, the only VLAN through which you can
gain management access to the switch. If you assign an IP address to any other
VLAN, the new IP address overrides the original IP address and this becomes
the new management VLAN.
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart (4-340)
ip default-gateway
This command establishes a static route between this switch and devices that exist on
another network segment. Use the no form to remove the static route.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
• A gateway must be defined if the management station is located in a different IP
segment.
• An default gateway can only be successfully set when a network interface that
directly connects to the gateway has been configured on the switch.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#