Installation manual

4-338
SIGNAMAX LLC • www.signamax.eu
IP Interface Commands
An IP addresses may be used for management access to the switch over your network.
The IP address for this switch is obtained via DHCP by default. You can manually
configure a specific IP address, or direct the device to obtain an address from a BOOTP
or DHCP server when it is powered on. You may also need to a establish a default
gateway between this device and management stations or other devices that exist on
another network segment.
ip address
This command sets the IP address for the currently selected VLAN interface. Use the no
form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask identifies the
host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management access over the
network. You can manually configure a specific IP address, or direct the device to
obtain an address from a BOOTP or DHCP server. Valid IP addresses consist of
four numbers, 0 to 255, separated by periods. Anything outside this format will not
be accepted by the configuration program.
Table 4-92 IP Interface Commands
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-338
ip default-gateway Defines the default gateway through which this switch can reach
other subnetworks
GC 4-339
ip dhcp restart Submits a BOOTP or DHCP client request PE 4-340
show ip interface Displays the IP settings for this device PE 4-340
show ip redirects Displays the default gateway configured for this device PE 4-341
ping Sends ICMP echo request packets to another node on the
network
NE,
PE
4-341