Installation manual

4-337
SIGNAMAX LLC • www.signamax.eu
The following shows information about the interfaces associated with multicast groups
assigned to the MVR VLAN:
The following shows the interfaces which have joined MVR receiver groups, and the
status of MVR traffic for each group:
Console#show mvr members
MVR Group IP Status Receiver VLAN Members
---------------- -------- ------------- -------
225.0.0.1 ACTIVE VLAN2 eth1/1(d), eth1/2(s)
225.0.0.2 INACTIVE None None
225.0.0.3 INACTIVE None None
225.0.0.4 INACTIVE None None
225.0.0.5 INACTIVE None None
225.0.0.6 INACTIVE None None
225.0.0.7 INACTIVE None None
225.0.0.8 INACTIVE None None
225.0.0.9 INACTIVE None None
225.0.0.10 INACTIVE None None
Console#
Table 4-90 show mvr members - display description
Field Description
MVR Group IP Multicast groups assigned to the MVR VLAN.
Status Shows whether or not the there are active subscribers for this multicast group. Note that
this field will also display “INACTIVE” if MVR is globally disabled.
Receiver VLAN VLAN used to froward mutlicast traffic with tagged frames without revealing the identity of
the MVR VLAN
Members Shows the interfaces with subscribers for multicast services provided through the MVR
VLAN. Also shows if an interface has dynamically joined a multicast group (d), or if a
multicast group has been statically bound to the interface (s).
Console#show mvr receiver-group members
MVR Group IP Status Members
---------------- -------- -------
224.0.0.1 ACTIVE eth1/1
224.0.0.2 INACTIVE None
224.0.1.1 INACTIVE None
224.0.1.2 INACTIVE None
224.0.1.3 INACTIVE None
Console#
Table 4-91 show mvr receiver members - display description
Field Description
MVR Group IP Multicast groups assigned to the MVR Receiver VLAN.
Status Shows whether or not the there are active subscribers for this multicast group. Note that
this field will also display “ACTIVE” if an interface has been statically assigned to a group.
Members Shows the interfaces with subscribers for multicast services provided through the MVR
Receiver VLAN. Also shows if an interface has dynamically joined a multicast group (d),
or if a multicast group has been statically bound to the interface (s).