Installation manual

4-336
SIGNAMAX LLC • www.signamax.eu
The following displays information about the interfaces attached to the MVR VLAN:
Table 4-88 show mvr - display description
Field Description
MVR Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR environment
are satisfied.
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
MVR Max Multicast Groups Shows the maximum number of multicast groups which can assigned to the
MVR VLAN.
MVR Current Multicast
Groups
Shows the number of multicast groups currently assigned to the MVR VLAN.
MVR Receiver VLAN VLAN used to froward mutlicast traffic with tagged frames without revealing
the identity of the MVR VLAN
MVR Supported Receiver
Multicast Groups
Number of multicast groups to be managed through the receiver VLAN
MVR Used Receiver Multicast
Groups
Number of multicast groups currently active within the receiver VLAN
Console#show mvr interface
Port Type Status Immediate Leave
------- -------- ------------- ---------------
eth1/1 SOURCE ACTIVE/UP Disable
eth1/2 RECEIVER ACTIVE/UP Disable
eth1/5 RECEIVER INACTIVE/DOWN Disable
eth1/6 RECEIVER INACTIVE/DOWN Disable
eth1/7 RECEIVER INACTIVE/DOWN Disable
Console#
Table 4-89 show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source ports is
“ACTIVE” if MVR is globally enabled on the switch. MVR status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR groups, or a multicast group has been statically assigned to
an interface.
Immediate Leave Shows if immediate leave is enabled or disabled.