Installation manual

3-16
SIGNAMAX LLC • www.signamax.eu
Web – Click System, Bridge Extension Configuration.
Figure 3-5 Bridge Extension Configuration
CLI – Enter the following command.
Setting the Switch’s IP Address
This section describes how to configure an IP interface for management access over the
network. The IP address for the stack is obtained via DHCP by default. To manually
configure an address, you need to change the switch’s default settings to values that are
compatible with your network. You may also need to a establish a default gateway
between the switch and management stations that exist on another network segment.
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Console#show bridge-ext 4-238
Max support VLAN numbers: 256
Max support VLAN ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#